The Carbtune II comes in a small box as shown. If ordered with the Toolpouch then the packet will be slightly different.
Note: these instructions apply to the 4 column model. For the 2 column model, you will receive only half the contents and should make only two restricters.
Contents
This is what it looks like when you open the box.
On the left the Carbtune and rubber hoses.
On the right the plastic cable clip to hang gauges from the handlebars and inside the small plastic bag there are 4 x 5mm adapters, 4 x 6mm adapters and one fine bore thick wall clear plastic tube about 8cm (3”) long by 5mm (0.2”) diameter to make the restricters.
If ordered with the Toolpouch then the same contents will be packed inside the Toolpouch.
Contents of plastic bag
Damping. The restricters must always be used.
There are 4 x 5mm adapters, 4 x 6mm adapters and the restricter which you cut into four as below.
Construct restricters
see pictures right
4 x 2cm restricters
Remove 10cm from rubber tubing
10cm
Insert restricter
90cm tube > restricter > 10cm tube
Connect rubber tube
90cm tube connects to Carbtune; 10cm to carb
Insert clip
plastic cable clip to hang gauges from the handlebars fits through slot at top of Carbtune
You are now ready to balance your carbs or fuel injection bodies, so the next step is to Read the Manual
Morgan Carbtune Ltd Unit 33W Townsend Enterprise Park Townsend Street Belfast BT13 2ES United Kingdom
